![]() S2(config-if- range)# interface range f0/17 – 24 S2(config-if- range)# switchport access vlan 20 S2(config-if- range)# interface range f0/9 -16 S2(config-if- range)# switchport access vlan 10 S2(config-if- range)# switchport mode access Assign VLANs to ports on S2 using assignments from the table above.Create VLANs 20 and 30 according to the table below.Part 2: Create additional VLANs on S2 and S3. VLANs 99 and 999 are configured on all the switches. What VLANs are configured on the switches? ![]() On S1, go to privileged EXEC mode and enter the show vlan brief command to verify the VLANs that are present.ġ default active Fa0/1, Fa0/2, Fa0/3, Fa0/4.Verify the configured VLANs on the switches. Instructions Part 1: Verify VLAN configuration. You will configure trunk links between the switches, and you will configure VLAN 999 as the native VLAN. You will assign ports to VLANs and verify end-to-end connectivity between hosts in the same VLAN. In this activity, you will configure trunk links between the switches. To ease some of the VLAN and trunking configurations, trunk negotiation between network devices is managed by the Dynamic Trunking Protocol (DTP), and is automatically enabled on Catalyst 2960 and Catalyst 3650 switches. As the number of switches in a network increases, the administration necessary to manage the VLANs and trunks can be challenging.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |